Common faults and solutions of new type pneumatic waste cleaner
Is the newly purchased waste cleaning machine not reproduced? Many customers use it and feel that the scrapped cleaner is not damaged, so they will contact the manufacturer as soon as possible. According to the explanation of the manufacturer, it is understandable that the new scrapped cleaner will have a run-in period, running on the coordination degree of the chain and gear. With the operation of the chain slowly loosening, it is necessary to adjust the arm before the screw to tighten the chain, otherwise the service life of the chain will be affected. A week or so of operation will result in a period of coordination between the fuselage parts. Greatly improve the working efficiency of the machine, improve the efficiency of use.
The use of machinery is generally not smooth, after a period of time, how does the waste machine not turn? When you go back to the maintenance department, there are usually two things that happen.
1, the regulating valve is not adjusted by the operator to the pressure consistent with the operation of the machine, so that the waste cleaning machine can not work normally, or the performance is not strong.
2. There is waste paper in the chain and the main gear of the waste cleaner, which makes the chain of the waste cleaner difficult to rotate. The paper should be cleaned in time to make the chain slide smoothly.
3. The cylinder is blocked by dust and other impurities, and the blades can not work normally, which is usually caused by improper maintenance. Shengli Company sends oil to customers on each slag discharge machine, and is equipped with pneumatic tool oil to lubricate the oil, which can reduce interns. Aluminum wear. At the same time, it also has a cleaning function, even if a large amount of dust enters the machine when cleaning the waste, a few drops of oil also enter the machine when commuting every day, the dust can be washed away, so the speed will not be affected.
Maintenance of pneumatic tools is not maintenance. Oil should be dripped on the chain every day to ensure that it slides unimpeded. A few drops of tool oil from the air inlet, ventilated for a few seconds a day, can greatly increase the life of the machine.
