Before the automatic slitting machine equipment is put into work, check whether the working position is properly adjusted, the lubrication part should be added in advance. Check whether the cutting tool is sharp. When everything is normal, the automatic slitting machine can run empty first, check whether there is abnormal, and input the processing order into the computer in advance for inspection; After the automatic slitting machine is put into work, the best working state of the equipment should be adjusted in time according to the production situation to ensure that the indentation of the slitting machine is moderate, the slitting has no burr, and the trimming position of both sides is appropriate. To ensure that the crosscutting machine into and out of paper smoothly, the cutting length is accurate, the connection of the production management of the crosscutting machine, also need to constantly monitor its operation, to guard against paper blocking phenomenon and the generation of defective products; After the work is finished, timely clean up the dust and paper on the equipment, check the cutting tool and grinding wheel into the sky shuttle hand table, drain the water in the oil and water high device and gas storage tank, check whether the operation part is abnormal. Then, cut off the power and maintain the computer operating system according to the instructions.
1. before starting to ensure that the voltage, current and hydraulic equivalent is correct and stable.
2. Before the equipment is ready for operation, all personnel must inform to leave the equipment to ensure personal safety before starting up and running.
3. When running, do not touch the film or roll core in operation by hand, so as not to involve the hand and cause personal injury.
4. in the process of operation, do not use a knife or hard objects to scratch, cut each roller core.





